When the eg WinUsb driver gets installed they disable the original HID drivers that usually get preinstalled when a remote receiver is plugged in.
I would like to find out if it is possible to temporarily disable the eventghost winusb driver so that the old one takes over and then later re-enable it again.
I have had a look at EventGhost\eg\Classes\WinUsb.py that appears to handle the driver installation and its interface but I am not able to figure it out.
Hope someone can give me some hints on how that can be done.
Do you have questions about writing plugins or scripts in Python? Meet the coders here.
1 post • Page 1 of 1