Page 1 of 1

Enabling and disabling the winusb driver

Posted: Sat Jul 02, 2011 3:27 pm
by skat
When the eg WinUsb driver gets installed they disable the original HID drivers that usually get preinstalled when a remote receiver is plugged in.

I would like to find out if it is possible to temporarily disable the eventghost winusb driver so that the old one takes over and then later re-enable it again.

I have had a look at EventGhost\eg\Classes\ that appears to handle the driver installation and its interface but I am not able to figure it out.

Hope someone can give me some hints on how that can be done.