USB-UIRT TransmitIR action result

Questions and comments specific to a particular plugin should go here.
Post Reply
Posts: 31
Joined: Sun Jul 31, 2011 10:15 am

USB-UIRT TransmitIR action result

Post by reaper » Sat Oct 03, 2020 2:40 pm


the USB-UIRT TransmitIR command always returns that it wasn't successful, even if the IR signal was transferred.
Hence, the "Jump if last action was not successful" action can't be used.

I'd like to handle the "Device is not ready" error when an IR signal is to be sent on resuming from Windows standby, while the driver is still initialising.

Can this be fixed?

Post Reply