USB-UIRT "Device not Ready" How to execute Macro on Error

[aldi13]

I consistently have trouble with my USB-UIRT. It's stops responding and I get the following error in the log when I attempt to use the device to transmit an IR command.

"Device not Ready"

How can I use the error in the Log as an event to trigger a Macro? EG does not allow me to drag the error over to a Macro.

If anyone has any ideas on the USB-UIRT plugin I am open to those too.

I have tried moving my USB-UIRT away from other device to avoid interference.
I have added Ferrite Beads to USB & IR Blaster
I have device plugged into Powered USB Hub (My Only Option as I run USB-UIRT over USB Cat 5 Extender)

Thanks in advance

[Pako]

How can I use the error in the Log as an event to trigger a Macro? EG does not allow me to drag the error over to a Macro.

I've never tried it, but theoretically EventGhost Application Control Plugin could help.

Pako

[aldi13]

Thanks. Looking forward to testing.

[aldi13]

The plugin works perfectly. Thanks so much for pointing me in the right direction.

[Bob]

Hi,

I've got the same problem. Can you post an XML sample of your config to restart EG when USB UIRT "crashed" ?

Thanks in advance,

Bob

[aldi13]

I developed a sequence to restart the USB-UIRT but it never works. I always have to reboot the computer. The Devcon method doesn't seem to work for me. I can post some code later on when I get home.

[aldi13]

Take a look at this: http://www.eventghost.org/forum/viewtop ... 08f169fc8e