433mhz relay board control w/Tellstick help

[TiE]

Hi!

Is there anyone who has tried or had any Chinese relay board to work properly with TellStick?

I have a 8ch, and a 12ch board that I am trying to control with Tellstick.
The boards are mounted in DIY firingboxes to fire my 60mm - 130mm firework mortars.

The plan is to run Eventghost with the Timer, and Tellstick plugins.

Anyone with any clue

Kalle.

[sofiajoe]

I'm trying to launch HyperSpin with EventGhost. When I launch HyperSpin from the Start Menu it works fine, but with EG it doesn't seem to be the active window. I have to hit alt+tab to get any keypresses to work.

[krambriw]

1) If you cannot make them work directly using Telldus Center, it will not work with EG either

2) Have you tried to clear the memory completely on the board (I think you have to keep the learn button on the board pressed maybe 30 seconds)?

3) Have you figured out how you can learn all relays individually?

4) If so, start all over again and program them instead using Nexa code switch types (Typicall A1, A2, A3 etc) with one address per relay

What is the minimum delay between commands you need to trigger your FireWorks? TellStick needs a couple of seconds between each command.

The RFXtrx is better handling multiple commands and faster in sending them as well

Best regards