EventGhost

Sorry, my mistake

When you provide such good debugging information, really helps a lot!

I am not 100 if the attached version is fully correct so please try. Also I would appreciate if you do and attach more logging events from the RFXmngr. I can then use those to simulate in the plugin to get the decoding working.

BR

No worries, it's already very nice to help me with this termostat.
I'll try your new version and keep you informed

@ Walter
it's look working well !
I have recorded log with the last version of RFXmngr.
the periodicity of the signal transmission from the thermostat appears to be 05 mins 20 (with a few times, a jump at 10 mins 40)
Do you have a paypal account in order I give you a little gift to thank you for the help you give ?

@Stef
I have found some other issues and made further improvements. Could you use this version instead and see if it still works fine for you. I have tried to simulate as much as possible and it seems to be fully but you never know...

Kind regards, Walter

With your last version, it still works fine. I don't have no more issues. Thanks for your great work.
If you give me a paypal link, I will be very happy to thank you by a virtual beer
Stef (a happy french user !)

New version in the first post:
Now supporting:
- Thermostat1 Digimax
- Thermostat3 Mertik-Maxitrol G6R-H4 types

I have a couple Aoke relays and most of them i can┬┤t send off command. it work with the remote. On command work fine.

Have you learned them as AOKE using a RFXtrx action? Please post a screenshot of one of your 'not working' AOKE actions

Yes've trained them as Aoke in RFX. At the signal always works but not off the signal. On the supplied remote, I press eg 1 = on 2 = off. It is 0402010200
Packet Type = Receiver / Transmitter Message
subtype = Transmitter Response
Sequence nbr = 2
response = ACK, data correct Transmitted
when I send off. When I set it to toggle mode i can turn on and off when i send on command.

Have you tried with the RFXmngr program provided by RFXCOM?

Yes same result. The strange thing is that I have 12 relays one of them works but not the others.

Well, then it is not related to the EG plugin, there is a basic problem with the devices. Only advice I can give is to clear the memory completly on the device and re-learn them. Keep the learning button on the AOKE pressed for a long time to clear all learned codes

Ok I will try thanks

I have test it works fine to lern them with ARC.

Good to hear!
Yes, ARC worked fine for me as well but also learning them directly as AOKE worked fine for me (I also cleared all memory before starting)

- what type of AOKE do you have (I have separate single units with one relay)?
- what RFXtrx do you have (I have tested with the RFXtrx433E and latest firmware)?
- do you have latest firmware in your RFXtrx?