EventGhost

Took a guess and installed just the 1045 upgrade and I am so excited... Early results are that the "speedy buttons" are gone

To Smoker:
last update (1045) fixed the multiple MCE event problem for me; I would assume it will do the same for you, so go & try it :D

Going to hop right on this but am a little confused (just woke but can't wait to get this working). I see that there is a 1024 setup and then several updates ...

I wish I had found a solution but there hasn't been any help here in the forums so I've lived with it. However i've gotten more and more frustrated with it and pulled out my Haupaugge remotes.

The remote is Microsoft A9O-00007 WinXP Media Center Infrared Remote Control and I didn't install anything. I plugged in the usb connector and off it ran.

I did bring up EventGhost and watched the log (left pane) and could see the up/down buttons get "logged" multiple times for a single press.

I'm stumped here because I went into the configuration and removed all the autorepeat actions and yet when I press the up or down buttons on the remote, EventGhost still skips. Not every single time, if i am very careful and quick i can sometimes get it to go up/down a single time.

Is there ...

These are the up and down buttons that I'm talking about

I am not real clear what the autorepeat option is all about.
It's on but are my choices to increase the timing or to remove it ?
Can you educate me a little about the autorepeat function.

Greetings

I've got EventGhost installed but there is a problem with the buttons. They do not double click but they seem very sensitive. Like I said they do not double click but for instance the up and/or down button will speed up and down rather quickly.

Any recommendations on slowing this down ...

so i finally get the alt driver installed and now my system locks up very frequently

Are there tips to getting the alt driver to run smoothly ?

Can someone please clarify the need for the alt mce driver ? In plain language for me.

arggggggghhh ok got it now.... sheesh what a dummy I can be lol

Well what trips me up is this line in the instructions

In the Universal Serial Bus Controllers section, locate the entry for the remote, right click and select "Update Driver"

I wasn't sure but yes there is a "eHome Infrared Receiver" under the usb section. I did try to update the driver but it ...

Greetings Folks

I am trying to use EG with gbpvr also and I can't seem to get off the ground. I am trying to load the alternative mce driver but am failing.

I get to the control panel and under the usb section but do not find a item for my mce remote to replace with the alt driver.

Can someone ...